Communication Input
- Isolated Safety Barriers
- Signal Isolators
- Surge Protective Devices
- Safety Relays
- Isolated Intelligent I/O Modules
- Intelligent Gateways
- Industrial Data Optical Transceivers
- Online Dew Point Analyzers
- Data Acquisition Modules
- HART data converter
PHG-11TC-33M
Overview
The PHG-11TC-33M is signal isolator with communication signal , which can realize the two-way communication of RS-485 Half Duplex digital signal in the onsite and control room. The circuit provides power distribution for on-site instruments. The voltage value can be switched through the top dial switch. The specific operation method is shown in the chart below.
This product needs independent power supply, and the power supply, input and output are isolated.
Specifications
| Input | |
| Input signal | RS-485 Half Duplex Digital Signal |
| Distribution voltage | Provide power distribution for field instruments: 5V, 6V, 12V, 24V |
| Output: | |
| Output signal | RS-485 Half Duplex Digital Signal |
| Transmission delay | ≤10μs |
| Transmission rate | ≤1.2kbps~56kbps |
| Supply voltage | 20-35VDC |
| Power consumption | <3.6W (24V power supply, 6V/100mA power distribution) |
| LED indicator |
Green: Power indicator Yellow: The control room transmits signals to the site Red: transmitting signals from the site to the control room |
| Receiving and transmitting switching time | ≥20ms |
| Temperature parameters |
Working temperature: -20℃~+60℃ storage temperature:-40℃~+80℃ |
| Relative humidity | 10%~95% RH no condensation |
| Dielectric strength | ≥2000VAC/min(between input/output/power supply) |
| Insulation resistance | 100MΩ(500 VDC) (between input/output/power supply) |
| Electromagnetic compatibility | GB/T 18268(IEC 61326-1) |
| MTBF | 800000h |
| Wire requirements | Horizontal cutting surface ≥ 0.5mm2; Insulation strength ≥ 500V |
| Applicable field equipments | Communication interface device with RS-485 Half Duplex Digital Signal |
Dimension
Schematic diagram
Note:
1. The power rail function is an optional function, and users need to specify the power supply method when placing an order
The selection of power rail connectors can refer to page 89 of the "Annex"