Network Signal Surge Protective Devices
- Isolated Safety Barriers
- Signal Isolators
- Surge Protective Devices
- Safety Relays
- Isolated Intelligent I/O Modules
- Intelligent Gateways
- Industrial Data Optical Transceivers
- Online Dew Point Analyzers
- Data Acquisition Modules
- HART data converter
PHL-T-RJ45.PoE
Overview
According to IEC standard , special RJ45 plug socket is adopted to meet the technical requirements of 10/100Mbps PoE protocol, which can limit the surge to a certain voltage protection level in the shortest time (ps level), reduce the potential difference between wires, and protect the electronic circuit connected to the network communication port from lightning and transient high-voltage surge.
It is used to protect the interface between LPZ0B area and LPZ2 area and subsequent areas.
Main feature
Standard RJ45 Ethernet port
Fully shielded design
Wide frequency and small insertion loss
Installation of 35mm rail for signal network transmission equipment protection using PoE technology
Main technical parameters
| Rated operational voltage | 5VDC |
| Maximum operating voltage Uc | 6VDC |
| Nominal operating current IL | 100mA |
| Nominal discharge current In (8 / 20μs) | 2.5kA |
| Total nominal discharge current Imax (8 / 20μs) | 20kA |
| Lightning surge current limp (10 / 350μs) | 0.5kA |
| Protection voltage Up (under In) (8 / 20μs) line-to-line | ≤75V |
| Protection voltage Up (under In) (8 / 20μs) line to ground | ＜500V |
| Interface mode | Input/output: female seat/female seat |
| Bandwidth | 100MHz |
| Insertion loss | ＜-1.3dB |
| Response time | ＜1ns |
| Working temperature range | -20~+80℃ |
| Installation method | Optional DIN35mm rail mounting clamp |
| Grounding mode | 1.5mm² grounding conductor |
| Sheathing material | Black aluminum |
| Test standard | GB/T/8802.21/IEC 61643-21 |
Outline dimension diagram
Wiring method
