Input in hazardous area

Input signal

Switch contacts/proximity switches

The supply voltage of the sensor

About 8V

Switching rate

＜10kHz

Input/output characteristics:

On site input current

>2.1mA, the output is closed, indicating ON;
When<1.2mA, the output is open circuit, indicating OFF

Output normally "Open"/"Closed" Contact conversion control

When dial switch K1-K4 is at "ON" side, the relay output is "Normally closed"，when dial switch K1-K4 is at "OFF" side, the relay output is "Normally open".

Output in safe area

Output signal

Relay

Contact capacity

250VAC/2A,30VDC/2A when subjected to resistive loads

Response time

20ms

Basic parameters

Supply voltage

20~35V DC

Power consumption

≤85mA(24V power supply, when the relay contacts close)

LED indicator

Green: Power indicator
Red: LFD indication, line fault alarm

Temperature parameters

Working temperature: -20℃ ~ +60℃,
Storage temperature: -40℃ ~ +80℃

Relative humidity

10%~95% RH no condensation

Insulation strength

Between intrinsically safe side and non-intrinsically safe side (≥3000VAC/min);

Insulation resistance

≥100MΩ (between input/output/power supply)

EMC

According to IEC 61326-1 (GB/T 18268), IEC 61326-3-1

Wire requirements

Cross-section ≥ 0.5mm²; Insulation strength ≥ 500V

Applicable field equipments

Field equipment such as dry contacts or NAMUR type proximity switch inputs that comply with DIN19234 standard

Installation place

Installed in a safe zone, it can be connected to intrinsic safety instruments in hazardous areas up to Zone 0, IIC, Zone 20, and IIIC